-
Cast iron casting, class 25-30 25000# tensile strength
Oil-filled, hermetically-sealed, automatic reset thermal overload protected (1 Ph only) motor
Upper and lower ball bearing running in bath of oil
Mechanical shaft seal – carbon and ceramic rotary face seal, with stainless steel wetted parts
1117 carbon steel motor shaft (single seal models)
Stainless steel screws, bolts, washers and lifting bracket
Neoprene square ring and gasket
Maximum temperature: 130 °F (54 °C) standard
Variable level controls available
4” horizontal flanged discharge, standard ANSI flange
Passes 3” (76 mm) spherical solids
Corrosion-resistant, powder coated epoxy finish
Non-automatic available
Applications include:
- High capacity water removal – parking lots, low flood areas, water transfer
- To meet 3″ intake, 4″ discharge code requirements on some sewage applications
- Retrofit on existing sewage installations
- New installations
SHIPPING IS NOT FREE ON THIS PRODUCT
-
| Motor |
2 or 3 HP |
| Voltage |
200 - 575 V |
| Phase |
1 or 3 Ph |
| Hertz |
60 Hz |
| RPM |
1725 RPM |
| Type |
Permanent split capacitor or 3 phase |
| Insulation |
Class B |
| Amps |
4.1 - 20.2 Amps |
| Operation |
Automatic and non-automatic |
| Discharge Size |
4" horizontal ANSI flange |
| Solids Handling |
3" (76mm) spherical solids |
| Cord Length |
20′ (6 m) standard |
| Cord Type |
UL listed, 3-wire neoprene cord and plug |
| Max Head |
38′ (11.6 m) |
| Max Flow Rate |
361 GPM (1367 LPM) |
| Max Operating Temperature |
130 °F (54 °C) |
| Cooling |
Oil filled |
| Motor Protection |
Auto reset thermal overload (1 Ph) |
| Cap |
Cast iron |
| Motor Housing |
Cast iron |
| Pump Housing |
Cast iron |
| Base |
Cast iron |
| Upper Bearing |
Ball bearing |
| Lower Bearing |
Ball bearing |
| Mechanical Seals |
Carbon and ceramic |
| Impeller Type |
Non-clogging vortex |
| Impeller |
Cast iron |
| Hardware |
Stainless steel |
| Motor Shaft |
1117 carbon steel or 416 stainless steel* |
| Gasket |
Neoprene |
-
